It is important to ensure that every nook and cranny of a place rug is cleaned when cleaning it. That is why our 4-step guide starts with vacuuming and dusting, then proceeds straight to shampooing and drying.
The rug should be padded after which put back in its place while you take pictures or write your own notes so that you will know how to clean your area rug properly next time!
Clean an area rug on hardwood floor
Vacuum the location rug on each facets
Cleaning an area rug on a hardwood floor isn’t as difficult as some may believe. To begin with, you have to vacuum the surface of the carpet, disperse dirt particles using a hard-bristle brush, and finally use a vacuum cleaner with a hose and crevice tool for cleanup.
A forgotten patch can be easily covered using Rug Doctor machine while vacuuming or brushing. Once both sides are cleaned, it’s a piece of cake!
Shampoo the location rug
Cleaning an area rug on hardwood ground can cause an ache in the buttocks. However, it’s so worth it to keep your foot looking clean and vibrant! Follow these four simple steps to get it done:
1. Shampoo visibly dirty rugs in the vicinity by using soap mixed with water. 2. All dirt, stains will be removed by scrubbing brush carefully applied into them. 3. Clean until water runs clear then rinse off any excess soap suds through the hose pipe. 4.Don’t replace it till dry.
Rinse the area rug
Area rugs are often used in high-traffic areas such as living rooms or foyers where they tend to be more heavily used than any other domestic setting thus more often than not being dirtier than other home areas are because they are frequently utilized there too much;
therefore, they become lots dirtier than other residential zones do as well especially due to that fact that they are often used in high traffic areas like living rooms or foyers. Maintain your area rug clean and stain-free by following these simple steps: 1. Fill a bowl with water and add a little soap.
Soak the area rug in the bowl for at least 10 minutes. 2. Vacuum cleaner or hose should be used to remove excess water from the mat after emptying it out completely. 3.Spin (or shake) the rug before laying it down on its side so that any water is evenly disbursed. 4.It must be allowed to dry entirely before use.
Dry the area rug out
When hardwood flooring is being washed, you must remember all of its cleaning steps. These include vacuuming, washing and drying it. Make sure to vacuum and wipe under furniture and clear away any litter or dust.
Then, place a rug inside a tumble drier on low heat and wait till it gets baked. Lastly, whenever fresh stains come up, use an expert cleaner immediately. Just follow these simple procedures to ensure that your mat is clean and free from stains each time!
Read More: How to Clean Epoxy Floor With or without Soap
Frequently Asked Questions
Can I use a vacuum cleaner to clean an area rug?
While vacuuming appears as if it would be great for cleaning an area rug, this isn’t the case. Rugs should be scrubbed with a mop or brush instead of using a vacuum cleaner.
This not only is less effective but can also damage your floor if you are not careful. For six easy steps on how to clean an area rug on hardwood:
- 1.Spot-clean dirt and grime with mild soap.
- 2.Wipe the mat off with wet cloth.
- 3.Brush attachment of your vacuum cleanser helps in scrubbing baseboards, door frames as well as other hard surfaces close by.
- 4.Put water in the suction-cup tube inlet into your vacuum (approximately one inch above dirt so that dirt will be pulled into the system).
- 5.Turn on your vacuums and let them fully power up before cleaning rugs.
- 6.Remove the carpet off and dry it.
Can I machine wash my Area Rug?
No! Area rugs are not made for machine washers that might cause harm to them.Handwashing is considered best approach towards maintaining an area rug for wooden floors.
Six things to observe when handwashing a region’s carpet include: 1.Run water into sink then put in between folds of tissue paper until fully soaked.. 2.Massage through while washing the entire surface of the carpet using your hands. 3.
Apply a carpet cleaner or shampooing agent and rinse the carpet well. 4.Suspend it until fully dry. 5.Before storing away, ensure that you vacuumed it.
Conclusion
After going through this blog, you will know how to effectively clean an area rug on hardwood floor by vacuuming both sides, shampooing, rinsing and drying them out. Follow these steps for maintaining your carpets clean and fresh!
